SLICER
Chops your sound into a rhythmic pattern of short, sharp pieces.
What it does
SLICER cuts your sound into a repeating pattern of on and off. This turns an ordinary chord into a rhythmic, chopping sound.
You choose from twenty patterns and set how fast they run. With ATTACK and DUTY you shape how softly or hard the pieces start and how long they last.
How to use it
- Choose a pattern and set RATE to a note value such as 1/8 for a rhythm in the tempo of the song.
- Play a long chord and let the pattern turn it into a rhythm.
- Change ATTACK to make the start of the slices sharper or softer.
- Use it for an electronic, chopping mood.
Where it goes in the chain
Usually after the amp, so you put the rhythm on your final tone. Before delay and reverb for a rhythmic echo.
Starting points
Rhythmic chord
PATTERN P1 · RATE 1/8 · ATTACK 30 · DUTY 50
A long chord chopped in the tempo of your song.
Soft pulses
PATTERN P3 · RATE 60 · ATTACK 70 · DUTY 70
Longer slices with little silence between them.
Short ticks
PATTERN P5 · RATE 1/16 · ATTACK 10 · DUTY 25
Short blips for an electronic feel.
Every setting
| Setting | Range | What it does |
|---|---|---|
| PATTERN | P1 / P2 / P3 / P4 … P19 / P20 (20 steps) | Chooses the rhythm pattern from P1 to P20. Each pattern has its own order of pieces and silences. Try them to hear which fits your song. |
| RATE | 0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps) | The speed of the pattern: a number from 0 to 100, or a note value such as 1/4 or 1/8D, which follows the tempo (BPM) of the memory. |
| TRIGGER | OFF / ON | When you switch from OFF to ON, the rhythm pattern starts again from the beginning. When you save a memory, TRIGGER is stored as OFF. |
| EFFECT LEVEL | 0 to 100 | The volume of the effect. Keep it at 100 for an even volume, or adjust if the tone gets too quiet or too loud. |
| ATTACK | 0 to 100 | Sets the attack volume of the rhythm pattern. Try values to hear how sharp or soft the slices begin. |
| DUTY | 1 to 99 | How long the sound lasts within the pattern, from 1 to 99. Low gives short blips, high lets the sound run longer. |
| DIRECT MIX | 0 to 100 | The volume of the dry signal added to the mix. At 0 you hear only the pattern, higher fills the silences with your normal tone. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. SLICER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Modulation
Turn it yourself?
In GX Board, SLICER is a device in your rack, with all its controls on the front.