PRIME VIBRATO

A refined vibrato with a colour control and a mix for the dry signal.

What it does

PRIME VIBRATO lets the pitch rise and fall gently. It has extra controls: COLOR for a more complex modulation and DIRECT MIX for your dry tone. With DIRECT MIX at 0 you hear only the swaying tone. With more DIRECT MIX it moves toward a chorus-like swirl, because dry and wet sound blend.

With DIRECT MIX at 0 you hear only the swaying tone. With more DIRECT MIX it moves towards a chorus, because the dry and wet sound mix together.

How to use it

  • Set DEPTH low and RATE medium for a soft, expressive tone on long notes.
  • Set COLOR higher for a more complex modulation.
  • Raise DIRECT MIX for a swirl closer to a chorus.
  • Set RISE TIME higher so the vibrato builds up slowly after you switch it on.

Where it goes in the chain

Usually before the amp, or after your tone and before delay and reverb, so the tone shakes and the space stays steady.

Starting points

Singing note

RATE 60 · DEPTH 20 · TRIGGER ON · RISE TIME 45

A light wave that builds up slowly after you switch it on.

Floating colour

RATE 45 · DEPTH 40 · COLOR 50 · DIRECT MIX 40

A soft swirl between vibrato and chorus.

Clear wobble

RATE 70 · DEPTH 55 · TRIGGER ON · RISE TIME 0

A constant, audible pitch wobble.

Every setting

SettingRangeWhat it does
RATE0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps)The speed of the waving: a number from 0 to 100, or a note value such as 1/4 or 1/8D, which follows the tempo (BPM) of the memory.
DEPTH0 to 100How far the pitch waves. Low is subtle and vocal, high is clear and wobbly.
COLOR0 to 100Higher settings give a more complex modulation. Listen and pick what suits your tone.
EFFECT LEVEL0 to 100The volume of the vibrato signal. Keep it at 100 for an even volume, or adjust if the tone gets too quiet or too loud.
TRIGGEROFF / ONSwitches the vibrato on (ON) or off (OFF). After you switch it on, it builds up over the time set in RISE TIME.
RISE TIME0 to 100The time from switching TRIGGER on until the set vibrato is fully there. Higher makes it come in more slowly.
DIRECT MIX0 to 100The volume of the dry signal added to the mix. At 0 you hear only the vibrato, higher mixes your normal tone in.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PRIME VIBRATO in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, PRIME VIBRATO is a device in your rack, with all its controls on the front.

Download for Mac