DELAY

A plain digital echo with adjustable time, repeats and tone.

What it does

DELAY repeats what you play after a time you set. Each repeat is quieter than the one before, until it dies away.

A short time adds thickness. A long time gives separate echoes. HIGH CUT darkens the repeats so they stay behind your playing.

How to use it

  • Use a short TIME with little FEEDBACK for a single repeat that thickens your playing.
  • Pick a note value such as 1/4 or 1/8D for echoes that follow the tempo of your song.
  • Set FEEDBACK high and EFFECT LEVEL low for a long tail that hangs under your solo.
  • Turn HIGH CUT down when the echoes sound too sharp against your playing.

Where it goes in the chain

Usually after the amp, or after the drive and modulation. The repeats stay clear and your distortion does not get smeared by them.

Starting points

Slapback

TIME 120ms · FEEDBACK 10 · EFFECT LEVEL 45 · HIGH CUT 6.30kHz

A short, dry repeat that thickens your playing without sounding like an echo.

Solo echo

TIME 450ms · FEEDBACK 35 · EFFECT LEVEL 50 · HIGH CUT 4.00kHz

A clear echo with a dark tail, good under a melody.

Long space

TIME 700ms · FEEDBACK 55 · EFFECT LEVEL 35 · HIGH CUT 3.15kHz

Many repeats in the background for long notes and chords.

Every setting

SettingRangeWhat it does
TIME1ms / 2ms / 3ms / 4ms … 1/1D / 2/1 (2018 steps)The time between repeats, in milliseconds or as a note value such as 1/4 or 1/8D. A note value follows the tempo (BPM) of the memory.
FEEDBACK0 to 100How much of the echo is fed back into itself. Low gives one or two repeats, high a long tail. Very high can keep running.
EFFECT LEVEL0 to 120The volume of the echoes. Start low, around 30 to 50, and raise it until you just hear them in the mix.
DIRECT LEVEL0 to 100The volume of your dry signal. At 100 your guitar stays as it was; lower makes the echoes relatively louder.
HIGH CUT20.0Hz / 25.0Hz / 31.5Hz / 40.0Hz … 12.5kHz / FLAT (30 steps)Cuts the high end of the echoes. Lower values give darker repeats, FLAT lets everything through.
CARRYOVEROFF / ONON lets the echoes ring out after you switch the effect off. OFF cuts them off at once.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. DELAY in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, DELAY is a device in your rack, with all its controls on the front.

Download for Mac