ROTARY
Imitates a rotating speaker, with a slow and a fast speed.
What it does
ROTARY imitates the sound of a speaker with rotating parts. It gives a swirling, spacious movement that turns through the tone.
You switch between a slow and a fast speed. The change between the two is gradual, as on a real rotating speaker.
How to use it
- Choose SLOW for a calm, warm swirl under chords.
- Switch to FAST in a solo for a swirling tone.
- Set DRIVE a little higher for some extra distortion.
- Play with RISE TIME and FALL TIME for a realistic, slow change between the speeds.
Where it goes in the chain
Usually after the amp or after a clean tone, before delay and reverb. It also fits well after an organ-like sound.
Starting points
Calm rotation
SPEED SELECT SLOW · SLOW RATE 30 · EFFECT LEVEL 100
A soft, warm swirl under chords.
Swirling solo
SPEED SELECT FAST · FAST RATE 70 · DRIVE 20
A fast, rough rotation for a solo.
Realistic change
SPEED SELECT SLOW · RISE TIME 70 · FALL TIME 70 · DIRECT MIX 20
Slow speeding up and slowing down when you switch.
Every setting
| Setting | Range | What it does |
|---|---|---|
| SPEED SELECT | SLOW / FAST | Chooses the speed: SLOW for a calm swirl, FAST for a swirling one. You can switch it while you play. |
| SLOW RATE FAST RATE | 0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps) | The rotation speed of the SLOW setting, and with FAST RATE that of the FAST setting: a number from 0 to 100 or a note value such as 1/4 or 1/8D, which follows the tempo (BPM). |
| EFFECT LEVEL | 0 to 100 | The volume of the effect in the mix. Higher gives more rotating effect, lower lets your own tone lead. |
| RISE TIME FALL TIME | 0 to 100 | RISE TIME is the time the rotation takes to go from SLOW to FAST, FALL TIME the time from FAST to SLOW. Higher is a slower change. |
| MIC DISTANCE | 0 to 100 | Sets the distance between the horn or rotor and the mic. Listen and choose what fits. |
| ROTOR/HORN | 100:0 / 100:2 / 100:4 / 100:6 … 2:100 / 0:100 (101 steps) | Sets the volume balance between the rotor and the horn. The values run from 100:0 to 0:100. Listen to how the sound changes. |
| DRIVE | 0 to 100 | Sets the amount of distortion in the preamp. At 0 it sounds clean, higher gives more distortion. |
| DIRECT MIX | 0 to 100 | The volume of the dry signal added to the mix. At 0 you hear mostly the effect, higher lets more of your normal tone through. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. ROTARY in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Modulation
Turn it yourself?
In GX Board, ROTARY is a device in your rack, with all its controls on the front.