FLANGER
A sweeping, metallic swirl like a jet passing overhead.
There is a version for bass too: BASS FLANGER
What it does
FLANGER mixes your sound with a copy that is delayed very briefly, and that delay moves back and forth. This creates a sweeping, almost metallic tone.
With a lot of RESONANCE the sound gets sharp and whistling. With little it stays softer and closer to a chorus.
How to use it
- Set a slow RATE and medium DEPTH for a wide sweep under a chord.
- Set RESONANCE high for a sharp, whistling jet sound.
- Use STEP RATE to make the rate and depth change in steps.
- Raise DIRECT MIX if you want to keep more of the dry tone.
Where it goes in the chain
Before the amp for a rough, sharp sound, or after the amp for a smoother sweep. Before delay and reverb.
Starting points
Slow jet
RATE 15 · DEPTH 70 · RESONANCE 55 · MANUAL 50
A slow, sharp sweep through a chord.
Soft swirl
RATE 25 · DEPTH 40 · RESONANCE 20 · DIRECT MIX 50
A calm flanger that sits closer to a chorus.
Staircase
RATE 30 · DEPTH 60 · STEP RATE 1/8 · EFFECT LEVEL 80
A sweep whose rate and depth change in steps, in the tempo of your song.
Every setting
| Setting | Range | What it does |
|---|---|---|
| RATE | 0 / 1 / 2 / 3 … 1/16T / 1/32 (119 steps) | The speed of the sweep: a number from 0 to 100, or a note value such as 1/4 or 1/8D, which follows the tempo (BPM) of the memory. |
| DEPTH | 0 to 100 | How wide the sweep moves. Low stays close to one tone, high opens and closes the sound widely. |
| RESONANCE | 0 to 100 | Feeds part of the effect back in. Higher sounds sharper, more whistling and more metallic. Too high can get shrill. |
| MANUAL | 0 to 100 | The center frequency at which the effect works. Lower sounds deeper and thicker, higher sounds brighter and thinner. |
| STEP RATE | OFF / 0 / 1 / 2 … 1/16T / 1/32 (120 steps) | Sets the cycle of the step function, which makes the rate and depth change in steps. Higher gives finer changes. OFF leaves the step function out. |
| LOW CUT | FLAT / 20.0Hz / 25.0Hz / 31.5Hz … 10.0kHz / 12.5kHz (30 steps) | Sets the frequency from which low notes are filtered out. Higher keeps the bass tight, FLAT lets everything through. |
| EFFECT LEVEL | 0 to 100 | The volume of the flanger signal in the mix. Higher gives more sweep, lower lets your own tone lead. |
| DIRECT MIX | 0 to 100 | The volume of the dry signal added to the mix. At 0 you hear mostly the effect, higher lets more of your normal tone through. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. FLANGER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Modulation
Turn it yourself?
In GX Board, FLANGER is a device in your rack, with all its controls on the front.