PEDAL BEND
Bends your pitch with the expression pedal of the unit.
There is a version for bass too: BASS PEDAL BEND
What it does
PEDAL BEND bends your pitch with the expression pedal of the unit, or with an expression pedal on the CTL 3, 4/EXP 2 jack. The pedal moves the pitch between a lowest and a highest value in semitones.
That lets you drop or raise a note while you play, like a vibrato arm or a slide.
How to use it
- Set PITCH MIN to 0 and PITCH MAX to 12 to bend up an octave with the pedal.
- Set PITCH MIN to a negative value for a dive-bomb effect.
- Use it on a long held note for a singing, rising tone.
- Leave DIRECT MIX at 0 for a purely bent note, or raise it to let your normal sound play along.
Where it goes in the chain
Put PEDAL BEND early in the chain, before the overdrive or the amp, so the bent note is distorted along with it.
Starting points
Octave up
PITCH MIN 0 · PITCH MAX 12 · EFFECT LEVEL 100 · DIRECT MIX 0
With the pedal you bend the note up to an octave.
Dive
PITCH MIN -12 · PITCH MAX 0 · EFFECT LEVEL 100 · DIRECT MIX 0
With the pedal you let the note fall by up to an octave.
Every setting
| Setting | Range | What it does |
|---|---|---|
| PITCH MIN | -24 to 24 | The pitch when the pedal is fully raised (heel down), in semitones. 0 is no shift, negative goes lower. |
| PITCH MAX | -24 to 24 | The pitch when the pedal is fully pressed down, in semitones. 12 is an octave up, 24 two octaves. |
| PEDAL POSITION | 0 to 100 | Sets the pedal position as a number. Use it after you assign it to an expression pedal or another controller. |
| EFFECT LEVEL | 0 to 100 | Volume of the bent sound. At 100 you hear the effect in full. |
| DIRECT MIX | 0 to 100 | Volume of your unprocessed sound. At 0 you hear only the bent note, higher blends in your own tone. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. PEDAL BEND in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, PEDAL BEND is a device in your rack, with all its controls on the front.