BASS OCTAVE bass

Adds one or two octaves below your note for a heavy, deep sound.

The version for guitar: OCTAVE

What it does

The octaver listens to the pitch of your bass and adds a note one octave lower and one two octaves lower. That gives a deep, growling base under your normal sound.

DIRECT LEVEL sets how loud your own bass stays next to the extra octaves.

How to use it

  • Add -1 OCT for a thicker bass in choruses, without the low end getting unclear.
  • Raise -2 OCT for a heavy, synth-like bottom.
  • Keep DIRECT LEVEL at 100 so your own note stays clear.
  • Combine with a drive for a big, growling tone.

Where it goes in the chain

Put it early in the chain, after a compressor and before drive and amp. The octaver works best on a clean, even-level signal.

Starting points

Fat bass

-1 OCT 50 · -2 OCT 0 · DIRECT LEVEL 100

One extra octave below your note for choruses.

Deep growl

-1 OCT 40 · -2 OCT 60 · DIRECT LEVEL 80

A heavy, growling bottom end.

Every setting

SettingRangeWhat it does
-2 OCT0 to 100The volume of the note two octaves lower. Higher gives a very deep, almost sub-bass weight.
-1 OCT0 to 100The volume of the note one octave lower. Higher makes your bass thicker and fuller.
DIRECT LEVEL0 to 100The volume of your own bass next to the octaves. At 100 your note stays complete and the attack clear.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS OCTAVE in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, BASS OCTAVE is a device in your rack, with all its controls on the front.

Download for Mac