HARMONIST
Plays a second voice along with you, in the right key.
There is a version for bass too: BASS HARMONIST
What it does
HARMONIST adds one or two voices that follow your guitar line at a chosen interval, such as a third above. The voices follow a scale in the key you set for the memory.
Play single notes only, because the unit has to detect the pitch. A single line then sounds like a guitar duo.
How to use it
- Play a melody and set HARMONY to a third or fifth for a two-part lead.
- Choose 2 STEREO for two voices spread across left and right.
- Choose USER and set the shift per note yourself when the standard intervals do not suit a song.
- Raise PRE-DELAY a little for a voice that comes in slightly later and sounds looser.
Where it goes in the chain
Put HARMONIST early in the chain, before the overdrive and the amp, so the voices follow a clean signal and are distorted together afterwards.
Starting points
Duo lead
VOICE 1 VOICE · 1: HARMONY -3rd · 1: LEVEL 70 · DIRECT LEVEL 100
A melody sounds two-part, with the extra voice a little quieter.
Wide and deep
VOICE 2 STEREO · 1: HARMONY -12th · 2: HARMONY +2oct · 1: LEVEL 50 · 2: LEVEL 50
Two voices left and right, for a big, almost organ-like sound.
Every setting
| Setting | Range | What it does |
|---|---|---|
| VOICE | 1 VOICE / 2 MONO / 2 STEREO | Number of voices: 1 VOICE, 2 MONO (both voices together in the centre) or 2 STEREO (two voices spread across left and right). |
| 1: HARMONY 2: HARMONY | -2oct / -14th / -13th / -12th … +2oct / USER (30 steps) | The interval of the voice against your note, up to two octaves down or up. With USER, this picks which user scale is used. |
| 1: LEVEL 2: LEVEL | 0 to 100 | Volume of the voice. Low for a subtle addition, high for a clear second guitar line. |
| 1: PRE-DELAY 2: PRE-DELAY | 0ms / 1ms / 2ms / 3ms … 1/1D / 2/1 (319 steps) | Time between your direct sound and the voice. Normally leave it at 0 ms. A note value follows the tempo of the memory. |
| 1: FEEDBACK | 0 to 100 | How much of the voice is fed back, so it repeats. Keep it low, or you get a wash of notes. |
| DIRECT LEVEL | 0 to 100 | Volume of your own, unprocessed sound. At 100 your guitar stays up front. |
| HR1: C HR1: D♭ HR1: D HR1: E♭ HR1: E HR1: F HR1: F# HR1: G HR1: A♭ HR1: A HR1: B♭ HR1: B | 0 to 48 | The USER scale of voice 1: one setting per note, the shift in semitones for that note, up to two octaves either way. Only used with USER. |
| HR2: C HR2: D♭ HR2: D HR2: E♭ HR2: E HR2: F HR2: F# HR2: G HR2: A♭ HR2: A HR2: B♭ HR2: B | 0 to 48 | The USER scale of voice 2: one setting per note, the shift in semitones for that note, up to two octaves either way. Only used with USER. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. HARMONIST in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, HARMONIST is a device in your rack, with all its controls on the front.