BASS PEDAL BEND bass
Bends the pitch of your bass with a pedal, with your clean bass kept in.
The version for guitar: PEDAL BEND
What it does
Pedal bend shifts the pitch of your bass, controlled by an expression pedal or an automatic control. Between PITCH MIN and PITCH MAX you move the note up or down, in semitones.
DIRECT MIX blends your normal bass back in, so the bottom end stays firm.
How to use it
- For a dive or a quick rise during a solo or a fill.
- Set PITCH MIN to -12 and PITCH MAX to 0 for a heavy drop to an octave below.
- Use DIRECT MIX to keep the note itself in place while the bend slides over it.
- Use small ranges, for example 2 semitones, for a subtle bend.
Where it goes in the chain
Put it early in the chain, after a compressor and before drive and amp. Pitch detection works best on a clean signal.
Starting points
Octave dive
PITCH MIN -12 · PITCH MAX 0 · PEDAL POSITION 100 · DIRECT MIX 30
A heavy drop of your note to an octave below.
Small bend
PITCH MIN 0 · PITCH MAX 2 · PEDAL POSITION 50 · DIRECT MIX 50
A subtle upward bend of two semitones.
Every setting
| Setting | Range | What it does |
|---|---|---|
| PITCH MIN | -24 to 24 | The pitch when the pedal is fully raised (heel down). In semitones, negative is lower. |
| PITCH MAX | -24 to 24 | The pitch when the pedal is all the way down (toe down). In semitones, 24 is two octaves up. |
| PEDAL POSITION | 0 to 100 | The pedal position within the range. Low is towards PITCH MIN, high towards PITCH MAX. With a pedal connected it follows your foot. |
| EFFECT LEVEL | 0 to 100 | The volume of the shifted note. Higher is more effect. |
| DIRECT MIX | 0 to 100 | Blends your normal bass back in. Higher keeps more of your own note and the bottom end, at 0 you hear only the effect. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS PEDAL BEND in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, BASS PEDAL BEND is a device in your rack, with all its controls on the front.