OCTAVE
Adds a note one or two octaves below the one you play.
There is a version for bass too: BASS OCTAVE
What it does
OCTAVE plays a copy of each note you hit one or two octaves lower. You get a thicker, heavier sound, almost as if a bass is playing along.
It works best on single notes and lines, less on chords.
How to use it
- Play a single line with -1 OCT turned up for a sound that feels thicker without a second guitar.
- Use -2 OCT for a deep, almost synth-like layer under a riff.
- Play higher on the strings for clean tracking. On the low strings the sound gets messy fast.
- Keep DIRECT LEVEL high if you want to keep the attack of your own guitar.
Where it goes in the chain
Put OCTAVE early in the chain, before the overdrive and the amp, so the lower note is distorted along with the rest.
Starting points
Thick lead
-1 OCT 60 · -2 OCT 0 · DIRECT LEVEL 100
A single line sounds full and strong, with your own tone in front.
Deep layer
-2 OCT 60 · -1 OCT 40 · DIRECT LEVEL 80
A heavy, rumbling layer under a riff.
Every setting
| Setting | Range | What it does |
|---|---|---|
| -2 OCT | 0 to 100 | Volume of the note two octaves down. Higher means more depth and less clear pitch. Start low, it gets heavy quickly. |
| -1 OCT | 0 to 100 | Volume of the note one octave down. This is the thickener: higher gives a fuller, bass-like tone next to your own. |
| DIRECT LEVEL | 0 to 100 | Volume of your normal, unprocessed sound. At 100 your guitar stays up front. Lower puts more weight on the low notes. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. OCTAVE in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Pitch and simulation
Turn it yourself?
In GX Board, OCTAVE is a device in your rack, with all its controls on the front.