X OVERDRIVE

Overdrive that adjusts its distortion to each pitch range.

There is a version for bass too: X BASS OVERDRIVE

What it does

The X OVERDRIVE is an overdrive that gives each pitch range the distortion that suits it. Low and high notes both sound fitting, and the drive follows your picking.

There is no TYPE: you shape the sound with DRIVE, TONE and BOTTOM.

How to use it

  • Play chords with a medium DRIVE and hear every string.
  • Use a low DRIVE for a clean sound that just bites.
  • Use it as a push for an amp that already breaks up.
  • Stack it after a booster for an airy solo.

Where it goes in the chain

Usually before the amp, after the wah and the compressor, so it drives the amp.

Starting points

Open chords

DRIVE 40 · TONE 0 · LEVEL 55 · BOTTOM 0

A lively drive where every string can be heard.

Tight rock

DRIVE 65 · TONE -5 · LEVEL 50 · BOTTOM -10

A solid rhythm with a tight low end.

Airy lead

DRIVE 55 · TONE 10 · LEVEL 65 · DIRECT MIX 20

A bright lead that moves with your picking.

Every setting

SettingRangeWhat it does
DRIVE0 to 120How much distortion you hear. Low stays almost clean, high gets thick with long sustain. Turn it down if chords turn unclear.
TONE-50 to 50Makes the sound darker (minus) or brighter (plus). Set it to suit your guitar and amp.
LEVEL0 to 100The volume of the effect. Set it as loud as with the effect off, or higher for a solo.
BOTTOM-50 to 50More or less low end. Towards plus it gets fuller, towards minus tighter. Pull it back if it rumbles.
DIRECT MIX0 to 100Blends the untouched signal in with the distortion. More gives more attack and dynamics. 0 is distorted sound only.
SOLO SW
SOLO LEVEL
SOLO SW: OFF / ON
SOLO LEVEL: 0 to 100
SOLO SW switches to a tone that suits solos. SOLO LEVEL sets the volume while SOLO SW is on, so one switch brings your solo to the right level.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. X OVERDRIVE in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, X OVERDRIVE is a device in your rack, with all its controls on the front.

Download for Mac