X BASS OVERDRIVE bass

Overdrive for bass that fits its distortion to every pitch range, from low to high.

The version for guitar: X OVERDRIVE

What it does

This overdrive gives a fitting distortion over the whole range of the bass, from low to high notes. Your bass stays clearly audible even when you turn it up a lot.

DIRECT MIX blends your clean bass back in, so the bottom end stays firm.

How to use it

  • For an even overdrive in which low and high notes stay clear.
  • Raise DIRECT MIX if the low notes drop away at high DRIVE.
  • Turn TONE towards minus if the bite gets too sharp.
  • Turn SOLO SW on for a tone that suits a melody or solo.

Where it goes in the chain

Put it after the compressor and before the amp, so the amp helps shape the distortion.

Starting points

Bright bite

DRIVE 45 · TONE 10 · LEVEL 50 · DIRECT MIX 50

An open overdrive that stands out in the mix.

Solid rock

DRIVE 70 · TONE 0 · LEVEL 45 · DIRECT MIX 40

More push, with a firm bottom end.

Every setting

SettingRangeWhat it does
DRIVE0 to 120How much distortion you get. Low is a light warmth, high a clear growl.
TONE-50 to 50Turns the sound darker or brighter. Towards minus it gets softer, towards plus sharper.
LEVEL0 to 100The output volume. Set it until it sounds equally loud with and without the effect.
BOTTOM-50 to 50Shapes the low end. Towards minus the low end is cut, towards plus it is boosted.
DIRECT MIX0 to 100Blends your clean bass into the distortion. Higher gives a firmer low end, at 0 you hear only the drive.
SOLO SWOFF / ONSwitches to a tone that suits solos. You set its volume with SOLO LEVEL.
SOLO LEVEL0 to 100The volume while SOLO SW is on. Higher gives more lift for a solo.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. X BASS OVERDRIVE in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, X BASS OVERDRIVE is a device in your rack, with all its controls on the front.

Download for Mac