METAL DISTORTION
Heavy, tight distortion for metal and high gain.
There is a version for bass too: BASS METAL DISTORTION
What it does
The METAL DISTORTION gives a heavy distortion with a lot of gain, made for heavy riffs. The sound is tight and aggressive. It suits fast riffs and long leads.
TYPE chooses between four metal characters.
How to use it
- Play fast riffs with a medium DIST and a low BOTTOM.
- Set DIST high for lead notes with lots of sustain.
- Use METAL CORE for fast metal riffs.
- Play palm-muted chords and hear every attack.
Where it goes in the chain
Usually before the amp, after the noise suppressor or the compressor.
Starting points
Tight riff
TYPE METAL ZONE · DIST 65 · TONE 0 · LEVEL 50 · BOTTOM -15
A focused sound for fast riffs.
Heavy and low
TYPE METAL CORE · DIST 70 · TONE -5 · LEVEL 50 · BOTTOM 5
A heavy sound for low chords.
Sharp lead
TYPE METAL DS · DIST 80 · TONE 10 · LEVEL 60
Plenty of sustain for long notes.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | METAL DS / METAL ZONE / HM-2 / METAL CORE | METAL DS is made for heavy riffs. METAL ZONE covers old-style to slash metal. HM-2 is cranked up and compressed. METAL CORE is made for fast metal riffs. |
| DIST | 0 to 120 | How much distortion you hear. Low gives a gritty rock drive, high a dense, heavy wall. Turn it down if riffs turn unclear. |
| TONE | -50 to 50 | Makes the sound darker (minus) or brighter (plus). Adjust it so the distortion does not turn harsh. |
| LEVEL | 0 to 100 | The volume of the effect. Set it as loud as with the effect off, or higher for a solo. |
| BOTTOM | -50 to 50 | More or less low end. Towards plus it gets heavier, towards minus tighter. Go lower for fast riffs. |
| DIRECT MIX | 0 to 100 | Blends the untouched signal in with the distortion. More gives more attack. 0 is distorted sound only. |
| SOLO SW SOLO LEVEL | SOLO SW: OFF / ON SOLO LEVEL: 0 to 100 | SOLO SW switches to a tone that suits solos. SOLO LEVEL sets the volume while SOLO SW is on, so one switch brings your solo to the right level. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. METAL DISTORTION in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, METAL DISTORTION is a device in your rack, with all its controls on the front.