BASS OVERDRIVE bass
A light, warm overdrive for bass, with your clean low end blended in.
The version for guitar: OVERDRIVE
What it does
Overdrive gives your bass a light, warm distortion that softens when you play softer and growls more when you dig in. On bass it is about colour and grit, without the low end losing its power.
DIRECT MIX blends your clean bass back in, so the bottom end stays firm.
How to use it
- A light dirty edge for a rock or blues bass, with a low DRIVE.
- Raise DIRECT MIX if the drive makes the lowest notes thinner.
- Use BOTTOM to adjust the low end of the compact, driven sound.
- Turn SOLO SW on for a tone that suits a melody or solo.
Where it goes in the chain
Put it after the compressor and before the amp, so the amp helps shape the distortion. Modulation and echo go behind it.
Starting points
Light warmth
DRIVE 30 · TONE 0 · LEVEL 55 · DIRECT MIX 50
A careful dirty edge that leaves the low end alone.
Rock growl
DRIVE 65 · TONE 10 · LEVEL 50 · DIRECT MIX 40
A clear overdrive for rock and blues.
Every setting
| Setting | Range | What it does |
|---|---|---|
| DRIVE | 0 to 120 | How much distortion you get. Low is a light warmth, high a clear growl. |
| TONE | -50 to 50 | Turns the sound darker or brighter. Towards minus it gets softer, towards plus sharper with more bite. |
| LEVEL | 0 to 100 | The output volume. Set it until it sounds equally loud with and without the effect. |
| BOTTOM | -50 to 50 | Shapes the low end. Towards minus the low end is cut, towards plus it is boosted. |
| DIRECT MIX | 0 to 100 | Blends your clean bass into the distortion. Higher gives a firmer low end, at 0 you hear only the drive. |
| SOLO SW | OFF / ON | Switches to a tone that suits solos. You set its volume with SOLO LEVEL. |
| SOLO LEVEL | 0 to 100 | The volume while SOLO SW is on. Higher gives more lift for a solo. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS OVERDRIVE in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, BASS OVERDRIVE is a device in your rack, with all its controls on the front.