BASS METAL DISTORTION bass
Heavy, tight metal distortion for bass, with your low end blended in.
The version for guitar: METAL DISTORTION
What it does
This is a heavy, compact distortion with a lot of gain and a sharp, tight sound. On bass it is hard to keep the low end standing, because high gain eats the root of the note.
DIRECT MIX blends your clean bass back in, so the foundation stays firm and readable.
How to use it
- For an aggressive bass in metal and hardcore that cuts through two guitars.
- Set DIRECT MIX to 50 or higher to keep the root note.
- Use BOTTOM towards minus for a tighter, less booming low end.
- Turn SOLO SW on for a tone that suits a melody or solo.
Where it goes in the chain
Put it after the compressor and before the amp or speaker cabinet. Keep echo and modulation behind it to a minimum.
Starting points
Tight metal
DIST 70 · TONE 5 · LEVEL 45 · DIRECT MIX 55
A heavy, tight bass with a solid root note.
Brutal wall
DIST 95 · TONE 0 · BOTTOM -10 · DIRECT MIX 60
A lot of gain, with the clean bass carrying the low end.
Every setting
| Setting | Range | What it does |
|---|---|---|
| DIST | 0 to 120 | How much distortion you get. Low is a solid edge, high a dense, heavy wall. |
| TONE | -50 to 50 | Turns the sound darker or brighter. Towards minus it gets darker, towards plus sharper and more aggressive. |
| LEVEL | 0 to 100 | The output volume. Set it until it sounds equally loud with and without the effect. |
| BOTTOM | -50 to 50 | Shapes the low end. Towards minus the low end is cut, towards plus it is boosted. |
| DIRECT MIX | 0 to 100 | Blends your clean bass into the distortion. Higher gives a firmer low end, at 0 you hear only the metal distortion. |
| SOLO SW | OFF / ON | Switches to a tone that suits solos. You set its volume with SOLO LEVEL. |
| SOLO LEVEL | 0 to 100 | The volume while SOLO SW is on. Higher gives more lift for a solo. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. BASS METAL DISTORTION in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Drive
Turn it yourself?
In GX Board, BASS METAL DISTORTION is a device in your rack, with all its controls on the front.