WARP
A dream-like effect that you start with TRIGGER.
What it does
WARP gives your sound a dream-like character. You start it with TRIGGER and set the time with TIME.
It is an effect for moments, not for all the time. Switch it on at a chord or a long note and set LEVEL so that it fits your playing.
How to use it
- Start WARP on a long chord and play a melody over it.
- Use it for an intro or a quiet part, where the dream-like sound fills the space.
- Choose a note value for TIME if the effect should stay in time with the song.
- Put TRIGGER on a footswitch and switch it on at the moment you want.
Where it goes in the chain
After the amp and before the reverb. The reverb then sits around the effect.
Starting points
Floating layer
TIME 800ms · TRIGGER ON · LEVEL 50
A long time for a slow, dreamy effect under your playing.
Short loop
TIME 1/4 · TRIGGER ON · LEVEL 45
A short time in tempo, for a rhythmic dreamy effect.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TIME | 1ms / 2ms / 3ms / 4ms … 1/1D / 2/1 (2018 steps) | The delay time of the effect, in milliseconds or as a note value such as 1/4 or 1/8D. A note value follows the tempo (BPM) of the memory. |
| TRIGGER | OFF / ON | ON applies the WARP effect. Switch it on at the moment you want to hear it. |
| LEVEL | 0 to 100 | The volume of the effect sound. Start halfway and adjust until it sits well with your playing. |
| CARRYOVER | OFF / ON | ON lets the effect ring out after you switch the effect off. OFF cuts it off at once. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. WARP in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Echo
Turn it yourself?
In GX Board, WARP is a device in your rack, with all its controls on the front.