SEND/RETURN
Places an external pedal in the chain through the SEND and RETURN jacks.
What it does
SEND/RETURN sends your signal out of the SEND jack to an external pedal or device and brings it back through the RETURN jack. That way you can put a pedal outside the GX-100 at a fixed place in the chain.
You set the level of the signal there and back.
How to use it
- Put a favourite external pedal exactly between two effects of the GX-100.
- Send the signal to a separate device with BRANCH OUT.
- Set SEND LEVEL and RETURN LEVEL so the external pedal does not come in too loud or too soft.
- Switch INVERT on if the sound turns thin or hollow after the external pedal.
Where it goes in the chain
Put SEND/RETURN at the spot in the chain where you want the external pedal: for example before the amp for a distortion, or after it for a delay.
Starting points
External pedal
MODE NORMAL · SEND LEVEL 100 · RETURN LEVEL 100
The external pedal simply sits in the chain.
Blend the pedal in
MODE DIRECT MIX · SEND LEVEL 100 · RETURN LEVEL 100 · INVERT OFF
Your own sound plays along with the external pedal.
Every setting
| Setting | Range | What it does |
|---|---|---|
| MODE | NORMAL / DIRECT MIX / BRANCH OUT | NORMAL puts the external device in series. DIRECT MIX blends your direct sound with the external sound. BRANCH OUT only sends out and ignores RETURN: handy as a dry out. |
| SEND LEVEL | 0 to 200 | The level going to the external device. Higher gives a stronger signal for pedals that need it. |
| RETURN LEVEL | 0 to 200 | The level of the signal coming back. Not in BRANCH OUT. Set it so your sound does not get louder or softer when you switch the device on. |
| ADJUST | 0 to 100 | Adjusts the phase between the internal processing of the GX-100 and the external device. Not in BRANCH OUT. Listen and choose. |
| INVERT | OFF / ON | Flips the phase of the signal coming from the external device on RETURN. Not in BRANCH OUT. Switch it on if the sound turns thin when blending. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. SEND/RETURN in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Routing and looper
Turn it yourself?
In GX Board, SEND/RETURN is a device in your rack, with all its controls on the front.