DIVIDER
Splits the signal into two channels, A and B.
What it does
DIVIDER splits your signal into two channels: A and B. In each channel you can place your own effects, so two sounds run side by side.
DIVIDER always goes with a MIXER, which joins the two channels again.
How to use it
- Let channel A pass a dry guitar and channel B a heavy effect, and blend them afterwards.
- Put a filter on each channel to split the sound into low and high, each with its own effect.
- Use DYNAMIC to send hard-picked notes to one channel and soft-picked notes to the other.
- Choose DUAL to work with two separate channels.
Where it goes in the chain
Put DIVIDER at the point where you want to split the chain, and put a MIXER after it to join the channels again.
Starting points
Split low and high
MODE DUAL · A: FILTER LPF · A: CUTOFF FREQ 800Hz · B: FILTER HPF · B: CUTOFF FREQ 800Hz
Channel A gets the low tones and channel B the high, each with its own effect.
Two equal channels
MODE DUAL · A: FILTER OFF · B: FILTER OFF
Two full channels side by side, for example to blend two amps.
Every setting
| Setting | Range | What it does |
|---|---|---|
| MODE | SINGLE / DUAL | SINGLE uses only one channel, A or B. DUAL uses both channels A and B. |
| CH SELECT | A / B | Only in SINGLE. Chooses which channel, A or B, the signal uses. |
| MIX MODE | SWITCH / MIX | Only in SINGLE. SWITCH cuts off the tails of the old channel when you switch, so noise stops. MIX lets the tails of the old channel ring out. |
| A: DYNAMIC B: DYNAMIC | OFF / POLARITY+ / POLARITY- | Only in DUAL. OFF does not use it. POLARITY+ passes only notes picked harder than DYNAMIC SENS, POLARITY- only softer notes. |
| A: DYNAMIC SENS B: DYNAMIC SENS | 0 to 100 | Only in DUAL. The picking sensitivity: the line between soft and hard notes. Set it to your own touch. |
| A: FILTER B: FILTER | OFF / LPF / HPF | Only in DUAL. OFF is no filter, LPF passes only what is below the cutoff, HPF only what is above it. |
| A: CUTOFF FREQ B: CUTOFF FREQ | 100Hz / 125Hz / 160Hz / 200Hz … 3.15kHz / 4.00kHz (17 steps) | Only in DUAL. The filter frequency, from 100 Hz to 4 kHz. Only audible when a filter is on. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. DIVIDER in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Routing and looper
Turn it yourself?
In GX Board, DIVIDER is a device in your rack, with all its controls on the front.