REVERB
A reverb with five kinds of space, adjustable time and tone.
What it does
REVERB adds space to your sound. It sounds as if you play in a hall, a room or with a metal plate behind you.
You choose the type and how long the reverb lasts. PRE-DELAY and the filters set how much space you hear without blurring your playing.
How to use it
- Choose ROOM or STUDIO with a short TIME for a small, natural space.
- Choose HALL M or HALL S with a longer TIME for a big hall under your solo.
- Choose PLATE for a metallic reverb with clear highs that suits chords.
- Raise PRE-DELAY a little to keep your notes clear and let the reverb come in after them.
Where it goes in the chain
Usually the last effect in the chain, after the echoes. The reverb then surrounds everything you play, including the repeats.
Starting points
Small room
TYPE ROOM · TIME 0.8s · PRE-DELAY 10 · EFFECT LEVEL 25
A short, natural space that gives your playing a little air.
Big hall
TYPE HALL M · TIME 3.5s · PRE-DELAY 40 · EFFECT LEVEL 30 · LOW CUT 125Hz
A wide hall under long notes, with a slim low end.
Bright plate
TYPE PLATE · TIME 2.0s · PRE-DELAY 20 · EFFECT LEVEL 30 · HIGH CUT 8.00kHz
A bright, metallic reverb that suits chords.
Every setting
| Setting | Range | What it does |
|---|---|---|
| TYPE | HALL S / HALL M / PLATE / ROOM / STUDIO | The kind of space. HALL S is clear and spacious, HALL M mild, PLATE metallic with bright highs, ROOM a warm small room, STUDIO an open, distant ambience. |
| TIME | 0.1s / 0.2s / 0.3s / 0.4s … 9.9s / 10.0s (100 steps) | How long the reverb lasts. Short values give a small space, long ones a hall. For chords, 1 to 3 seconds often works well. |
| PRE-DELAY | 0 to 200 | The time between your note and the start of the reverb. Higher keeps your playing clearer and makes the space a bit bigger. |
| DENSITY | 1 to 10 | How dense the reverb is. High values sound smooth, low values let single echoes show. Choose by taste. |
| EFFECT LEVEL | 0 to 100 | The volume of the reverb. Start around 20 to 30 and raise it until you just hear the space. |
| LOW CUT HIGH CUT | LOW CUT: FLAT / 20.0Hz / 25.0Hz / 31.5Hz … 630Hz / 800Hz (18 steps) HIGH CUT: 630Hz / 800Hz / 1.00kHz / 1.25kHz … 12.5kHz / FLAT (15 steps) | Cut the low and high end of the reverb. A higher LOW CUT and lower HIGH CUT keep the reverb slim and soft, so it does not cloud your playing. |
| DIRECT LEVEL | 0 to 100 | The volume of your dry signal. At 100 your guitar stays as it was. |
| CARRYOVER | OFF / ON | ON lets the reverb ring out after you switch the effect off. OFF cuts it off at once. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. REVERB in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Reverb
Turn it yourself?
In GX Board, REVERB is a device in your rack, with all its controls on the front.