TOUCH WAH

A wah that moves with how hard you pick.

There is a version for bass too: BASS TOUCH WAH

What it does

The TOUCH WAH is a wah you do not control with your foot but with your picking. Hit a note hard and the filter sweeps open, then falls back. It gives a funky, quacking sound without a pedal.

FILTER and POLARITY set how the filter sounds and which way it moves.

How to use it

  • Play funk riffs and short notes for a quacking sound.
  • Use it on bass for a round, bouncy sound.
  • Set SENS lower for a subtle movement on chords.
  • Use the HPF setting for a sharper, thinner effect.

Where it goes in the chain

Usually first in the chain, before the drives, so the filter hears your picking directly.

Starting points

Funk quack

FILTER BPF · POLARITY UP · SENS 60 · FREQUENCY 30 · RESONANCE 70 · DECAY 40

A short, quacking wah for funk riffs.

Soft movement

FILTER LPF · POLARITY UP · SENS 35 · RESONANCE 40 · DECAY 70

A soft, warm movement on chords.

Reverse wah

FILTER BPF · POLARITY DOWN · SENS 55 · DECAY 60

A filter that falls down after the attack.

Every setting

SettingRangeWhat it does
FILTERLPF / BPF / HPFLPF lets the low notes through and sounds round and warm. BPF lets the mid range through and sounds like a wah. HPF lets the highs through and sounds thin.
POLARITYDOWN / UPThe direction of the sweep. UP sweeps the filter up when you pick, DOWN sweeps it down.
SENS0 to 100How strongly the filter reacts to your picking. Higher gives a stronger wah. At 0 the strength of your picking has no effect. Lower it if it quacks too much.
EFFECT LEVEL0 to 100The volume of the filtered sound. At 100 you hear it fully. Set it lower to blend with the untouched sound.
FREQUENCY0 to 100The centre frequency of the wah. Low gives a darker, high a brighter sound. Set it so the movement stays easy to hear.
RESONANCE0 to 100The emphasis on the filter peak. Low sounds soft, high sounds sharp and nasal. Too high can whistle.
DECAY
not verified
0 to 100Sets the rate at which the filter moves. Try different values until the wah follows your playing the way you like.
DIRECT MIX0 to 100Blends the untouched signal in with the effect. 0 is filter only. More keeps the note clear.

The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. TOUCH WAH in the BOSS Parameter Guide · GX-100 manuals at BOSS

Turn it yourself?

In GX Board, TOUCH WAH is a device in your rack, with all its controls on the front.

Download for Mac