NOISE SUPPRESSOR
Mutes noise and hum when you are not playing.
What it does
The noise suppressor turns the sound down as soon as you stop playing. That way you do not hear hiss or hum in the pauses, especially with a lot of gain.
THRESHOLD sets the level where it steps in. RELEASE sets how quickly it closes again.
How to use it
- Use it with a high-gain tone to remove hiss and hum between notes.
- Put it after your amp or distortion, so the noise from those is removed too.
- Set RELEASE slower so long notes are not cut off abruptly.
- Set THRESHOLD just high enough to stop the noise, not higher.
Where it goes in the chain
Put it after the amp and distortions. Then it hears the noise they make and removes it.
Starting points
Subtle
THRESHOLD 20 · RELEASE 40
Removes light noise without you noticing.
Tight high gain
THRESHOLD 50 · RELEASE 25
Keeps a heavy tone completely quiet in the pauses.
Every setting
| Setting | Range | What it does |
|---|---|---|
| THRESHOLD | 0 to 100 | The level below which the sound is muted. Higher mutes earlier and more, but can cut off soft notes or fading chords. |
| RELEASE | 0 to 100 | How fast the sound is closed down. Short cuts off quickly, slow lets notes fade out naturally. |
| DETECT | INPUT / NS INPUT | What it listens to. INPUT follows your input jack and is the normal choice. NS INPUT follows the level at the suppressor's own input, for when it should not cut delay or reverb tails. |
The settings were checked against the BOSS GX-100 Parameter Guide, version 2.00. This explanation was written by the makers of GX Board, not by BOSS. The official description of every setting is in the BOSS Parameter Guide. NOISE SUPPRESSOR in the BOSS Parameter Guide · GX-100 manuals at BOSS
More in Dynamics and volume
Turn it yourself?
In GX Board, NOISE SUPPRESSOR is a device in your rack, with all its controls on the front.